added updated tinypinchange and associated libraries to support PRO

hardware/digistump/avr/libraries/DigisparkIRLib/examples/IRsendJVC/IRsendJVC.ino

@@ -0,0 +1,37 @@
+/* Example program for from IRLib – an Arduino library for infrared encoding and decoding
+ * Version 1.0  January 2013
+ * Copyright 2013 by Chris Young http://cyborg5.com
+ * Based on original example sketch for IRremote library 
+ * Version 0.11 September, 2009
+ * Copyright 2009 Ken Shirriff
+ * http://arcfn.com
+ */
+/*
+ * JVC sends repeat codes that are identical to the regular JVC codes
+ * however they have no header. Therefore there is an additional parameter
+ * that tells you whether or not to send as an original code or as a repeat.
+ *
+ * The only device I had to test this protocol was an old JVC VCR. It would only work if at least
+ * 2 frames are sent separated by 45us of "space". All JVC is the same bit length so we use
+ * the third parameter as a to tell it whether or not to send the header.
+ * Once with  the third parameter "1" then delay about 50 microseconds and send again
+ * with the third parameter "0".
+ */
+
+#include <IRLib.h>
+
+IRsend My_Sender;
+
+void setup()
+{
+  Serial.begin(9600);
+}
+
+//send a code every time a character is received from the serial port
+void loop() {
+  if (Serial.read() != -1) {
+    My_Sender.send(JVC,0xc2d0,1);   delayMicroseconds (50);
+    My_Sender.send(JVC,0xc2d0,0);   delayMicroseconds (50);
+  }
+}
+