/* Example program for from IRLib – an Arduino library for infrared encoding and decoding
 * Version 1.1  April 2013 by Chris Young http://cyborg5.com
 * "IRservo" Control a servo using an IR remote
 */
#include <IRLib.h>
#include <Servo.h> 
// You will have to set these values depending on the protocol
// and remote codes that you are using. These are from my Sony DVD/VCR
#define MY_PROTOCOL SONY
#define RIGHT_ARROW   0x86bca //Move several clockwise
#define LEFT_ARROW    0x46bca //Move servo counterclockwise
#define SELECT_BUTTON 0xd0bca //Center the servo
#define UP_ARROW      0x42bca //Increased number of degrees servo moves
#define DOWN_ARROW    0xc2bca //Decrease number of degrees servo moves
#define BUTTON_0 0x90bca  //Pushing buttons 0-9 moves to fix positions
#define BUTTON_1 0x00bca  // each 20 degrees greater
#define BUTTON_2 0x80bca
#define BUTTON_3 0x40bca
#define BUTTON_4 0xc0bca
#define BUTTON_5 0x20bca
#define BUTTON_6 0xa0bca
#define BUTTON_7 0x60bca
#define BUTTON_8 0xe0bca
#define BUTTON_9 0x10bca

IRrecv My_Receiver(11);//Receive on pin 11
IRdecode My_Decoder; 
Servo My_Servo;  // create servo object to control a servo 
int pos;         // variable to store the servo position 
int Speed;       // Number of degrees to move each time a left/right button is pressed
 
void setup() 
{ 
  My_Receiver.No_Output();//Turn off any unused IR LED output circuit
  My_Servo.attach(9);  // attaches the servo on pin 9 to the servo object 
  pos = 90;            // start at midpoint 90 degrees
  Speed = 3;           // servo moves 3 degrees each time left/right is pushed
  My_Servo.write(pos); // Set initial position
  My_Receiver.enableIRIn(); // Start the receiver
} 
 
void loop() 
{ 
    if (My_Receiver.GetResults(&My_Decoder)) {
       My_Decoder.decode();
       if(My_Decoder.decode_type==MY_PROTOCOL) {
          switch(My_Decoder.value) {
            case LEFT_ARROW:    pos=min(180,pos+Speed); break;
            case RIGHT_ARROW:   pos=max(0,pos-Speed); break;
            case SELECT_BUTTON: pos=90; break;
            case UP_ARROW:      Speed=min(10, Speed+1); break;
            case DOWN_ARROW:    Speed=max(1, Speed-1); break;
            case BUTTON_0:      pos=0*20; break;
            case BUTTON_1:      pos=1*20; break;
            case BUTTON_2:      pos=2*20; break;
            case BUTTON_3:      pos=3*20; break;
            case BUTTON_4:      pos=4*20; break;
            case BUTTON_5:      pos=5*20; break;
            case BUTTON_6:      pos=6*20; break;
            case BUTTON_7:      pos=7*20; break;
            case BUTTON_8:      pos=8*20; break;
            case BUTTON_9:      pos=9*20; break;
          }
        My_Servo.write(pos); // tell servo to go to position in variable 'pos' 
       }
     My_Receiver.resume();
    }
}